Stuart-turner Kennet 2 Manual do Utilizador

CENTRIFUGAL PUMPSOPERATING INSTRUCTIONSPlease leave this instruction booklet with the pump as it contains maintenance and safety information(Original

- 10 -Cont ...Supply Cord Extension (Thame, Loddon and X201 range)If the supply cord of the pump needs to be extended use the same specification as fi

- 11 -Cont ...Cable Gland & Supply Cord Fitting Instructions (Kennet single phase range)The cable gland assembly Fig. 12 (items 1 & 2) provide

- 12 -Cont ...Cable Gland & Supply Cord Fitting Instructions (Kennet three phase range)The cable gland assembly Fig. 15, (items 1 & 2) provide

- 13 -Cont ...Wiring DiagramsThe supply cord and internal wiring within the terminal box are routed and secured to ensure compliance with the electric

- 14 -Cont ...1. System Flushing Some pumps incorporate plastic components that must not come into contact with solder flux, acid-based descalen

- 15 -Cont ...5. Starting a) Switch on power to the pump which will now be operational. b) If pump has a three phase supply, confirm the direction

- 16 -Cont ...Cleaners, Disinfectants and DescalentsOn installations where chemical disinfectants or descalents are periodically used, the compatibili

- 17 -Cont ...PERFORMANCE INFORMATIONPerformance curves are based on liquids having the same specific gravity and viscosity as clean water at 20°C.NOT

- 18 -NOTES

- 19 -NOTES

- 2 -Cont ...MODELSKennet K7-2Kennet K9-2Kennet K12-2Thame T6-2Thame T12-2Loddon L5-4SLoddon L7-4SX201INDEX . . . . . . . . . . . . . . . . . Page No

Stuart Turner Ltd, Henley-on-Thames, Oxfordshire RG9 2AD ENGLAND Tel: +44 (0) 1491 572655, Fax: +44 (0) 1491 573704email: pumps@stuart-turn

- 3 -PRODUCT DESCRIPTIONMotor: Induction type, totally enclosed fan ventilated cooling, continuously rated, class ‘F’ insulation. Motors comply with

- 4 -Cont ...Stuart Turner reserve the right to amend the specification in line with its policy of continuous development of its products.Note: For i

- 5 -Cont ...CONNECTIONSPump Type Voltage Inlet Outlet Fig. NoK7-2 230/1/50 G1 Female G1 Female 1K9-2 230/1/50 G1 Female G1 Female 1K9-2 400/3/50 G1 F

- 6 -Cont ...SITING OF THE PUMP/PIPEWORKWARNINGS:  Pump Location If possible site the pump in a location where in the unlikely event of a liqui

- 7 -Mounting Foot SecuringSome pumps within the range are fitted with plastic mounting feet. If there is a requirement to secure the pump via the mo

- 8 -Cont ...ELECTRICAL INSTALLATIONWARNINGS:  The electrical installation must be carried out in accordance with the current national electrica

- 9 -Cont ...Certain installations may require additional earthing arrangements such as equipotential bonding. Reference should be made to the releva